GET STUCK AUTO-MIX DISPENSING GUN

USE WITH AUTO-MIX KITS TO DISPENSE A FULLY MIXED, 3/16" DIAMETER BEAD OF GLUE

Mr. Sticky's Auto-Mix Dispensing Gun, used in concert with Mr. Sticky's 57-gram Auto-Mix cartridges and mixers, allows automatic dispensing of mixed adhesives. The gun is lightweight, allows single-handed operation, even underwater. Does not include any glue or mixers.

How To Load The Dispensing Gun:

1. On the top of the gun, pull up on the black clip and rotate it down approximately 180˚.

2. Slide the gray plunger into the gun.. a. Hold the plunder with the teeth down. b. slide the rounded part of the plunger into the slot on the end of the gun where you rotated down the black clip. c. Slide it all of the way in.

3. Load the syringe into the black clip .. a. rotate the black clip 1/2 way back so that the part that clips is pointing upwards. b. insert the syringe into the large hole rimmed by black plastic beneath the clip. c. rotate the clip holding the glue back to its original position and snap it closed.

4. Remove the cap on the syringe and replace it with the mixing tip.

5. Squeeze the trigger to dispense the glue.

Note: If the syringe is below about 80˚F, soak it for a few minutes in hot water (about 100˚F) to make the glue flow easily. The glue can be dispensed at lower temperatures but is more difficult to push through the mixer.